ABB PVS300 Manual descargar pdf (Pagina 38)

38 Planning the installation

 Recommended AC output power cable types

The power cable types that can be used for the inverter AC output are shown below.

Shielded cable with line and neutral conductors and a concentric

PE conductor as shield. The shield must meet the PE conductor

cross section requirements, see General rules on page 37. Check

with local / state / country electrical codes for allowance.

Shielded cable with line and neutral conductors and a concentric

PE conductor as shield. A separate PE conductor is required if the

shield does not meet the cross section requirements, see General

rules on page 37.

Double insulated cable with line, neutral and PE conductors. A

separate PE conductor is required if the shield does not meet the

cross section requirements, see General rules on page 37.

1 Insulation jacket

2 Copper wire screen

3 Cable cores

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 129 130

Sin comentarios

ABB PVS300 Manual Pagina 38