ABB FDNA-01 Manual de usuario descargar pdf (Pagina 20)

Quick start-up guide

Mechanical and electrical installation

• Insert the FDNA-01 into its specified slot in the drive.

• Fasten the screw.

• Plug the fieldbus connector into the module.

Drive configuration

Note: Configuring the drive for communication with the module is

dependent on the drive type. Refer to the Firmware Manual of the

drive for detailed information on configuring the drive to use the

communication module.

• Power up the drive.

• Configure drive to enable module. With an ACS350 drive, set

parameter 98.02 COMM PROT SEL to EXT FBA.

• Verify that FBA TYPE is DEVICENET. On the ACS350 drive,

this is parameter 51.01.

• Configure drive to accept Start/Stop, Direction, Reference, Run

Enable and Fault Reset from module. Examples of appropriate

values on the ACS350 are shown in the following tables.

• Configure module via fieldbus configuration groups for desired

network characteristics. Examples of appropriate values on the

ACS350 are shown in the following tables.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 113 114

Sin comentarios

ABB FDNA-01 Manual de usuario Pagina 20