ABB FPBA-01 Manual de usuario descargar pdf (Pagina 48)

Communication profiles

7 RESET 0 ⇒ 1 Fault reset if an active fault exists. Proceed to SWITCH-

ON INHIBIT.

Note: This bit is effective only if the fieldbus interface is

set as the source for this signal by drive parameters.

0 (Continue normal operation)

8 INCHING_1 Inching 1. (Not supported by all drive types)

9 INCHING_2 Inching 2. (Not supported by all drive types)

10 REMOTE_

CMD

1 Fieldbus control enabled.

0 Control Word <> 0 or Reference <> 0: Retain last Control

Word and Reference.

Control Word = 0 and Reference = 0: Fieldbus control

enabled.

11 Vendor-specific bit as defined by PROFIdrive parameter

933.

12 Vendor-specific bit as defined by PROFIdrive parameter

934.

13 Vendor-specific bit as defined by PROFIdrive parameter

935.

14 Vendor-specific bit as defined by PROFIdrive parameter

936.

15 Vendor-specific bit as defined by PROFIdrive parameter

937.

Bit Name Value Proceed to STATE/Description

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 125 126

Sin comentarios

ABB FPBA-01 Manual de usuario Pagina 48